How It Works

Using the palm of your hand, press the T-Post Hook against the t-post.

Use wire pliers to clip the T-Post Hook onto the t-post.

After laying out barbed wire, place wire in the hook to hold wire while being stretched.

Once wire is tight, put permanent clip in place.

Remove the T-Post Hook, place in bucket, and use for next stretch of wire or next project.

Turn the "hook" upside down to hold wire down when you are going over a low spot or a ditch.

Clip one "hook" on for each strand of wire. Place up to approximately 125 feet apart, or about every 10-12 T-posts.

Get in touch with any questions